Product Description

LAP is a water soluble, cytocompatible, photoinitiator for use in the polymerization of hydrogels or bioinks. This photoinitator is preferred over Irgacure 2959 for biological applications due to its increased water solubility, increased polymerization rates with 365 nm light, and absorbance at 400 nm allowing for polymerization with visible light. The improved polymerization kinetics enable cell encapsulation at reduced initiator concentration and longer wavelength light, which has been shown to reduce initiator toxicity and increase cell viability.


This LAP product is considered non-sterile. Adding antibiotics to your cell culture system, or sterile filtering is recommended. To sterile filter, resuspend the desired quantity of LAP and filter through small 0.2 micron button filters. Use the sterile photoinitiator within 2 weeks.

This product comes with 500 mg of dry powder.

Storage/Stability:

The product ships on gel packs. Store the product at 2-8°C. Weigh out the required amount of  powder to solubilize. Once solubilized, use within 2 weeks.

Dry powder (non-solubilized) is stable for >1 year at 2-8°C.

Directions for Use

NOTE: For LAP, the below recommendations will result in a ~0.03% final LAP concentration. For some applications, such as DLP printing, the final LAP concentration should be increased to ~0.25-0.5%. 

  1. Calculate the volume of photoinitiator to add by multiplying the volume of hydrogel solution or bioink by 0.02. If the resulting number is 200 ul, for example, you will add 200 ul of LAP.
  2. Solubilize the required amount of LAP (per step 1) at a concentration of 17 mg/ml in 1X PBS or cell culture media.
  3. Add the calculated volume of photoinitiator to the required volume of hydrogel or bioink solution and mix thoroughly.
  4. Add your cells to the HA solution if desired.
  5. Dispense or bioprint your solution into the desired cultureware (i.e. 6-well plate, 48-well plate).
  6. For photocrosslinking, place the hydrogel solution directly under a 405 nm light crosslinking source.
  7. You may tune photoinitiator concentration, light intensity and photocrosslinking time to customize final hydrogel stiffness.

Product Q & A

We have recently been using this off-the-shelf 405nm Blue Light from Amazon (Click Here).

For our initial LAP crosslinking studies with methacrylated hydrogels, this lamp seems to work great, but we are working on validating this lamp for tissue engineering and cell culture purposes (confirming the wavelength, light intensity, etc...). 

 

Product Certificate of Analysis

No result for .

Safety and Documentation

Safety Data Sheet

Product Disclaimer

This product is for R&D use only and is not intended for human or other uses. Please consult the Material Safety Data Sheet for information regarding hazards and safe handling practices.